|
| |
|
 |
Dinosaur DDT-1 Distortion
- Input Impedance: 300 kOhm minimum
- Output Impedance: 200 Ohm maximum
- Gain: 50 dB maximum
- S/N Ratio: 85 dB
- Frequency Response: 70 Hz to 5 KHz
- Size: 4.8" L x 2.8 W x 2.0" H
- Weight 305 g
|
| |
|
 |
Dinosaur
DOD-1 Overdrive
- Input Impedance: 300 kOhm minimum
- Output Impedance: 200 Ohm maximum
- Gain: 50 dB maximum
- S/N Ratio: 85 dB
- Frequency Response: 70 Hz to 5 KHz
- Size: 4.8" L x 2.8 W x 2.0" H
- Weight 305 g
|
| |
|
 |
Dinosaur DCP-1 Compressor
- Input Impedance: 300 kOhm minimum
- Output Impedance: 200 Ohm maximum
- Gain: 0 dB maximum
- S/N Ratio: 85 dB
- Frequency Response: 70 Hz to 5 KHz
- Size: 4.8" L x 2.8 W x 2.0" H
- Weight 310 g
|
| |
|
 |
Dinosaur DUM-1 Ultra-Metal
- Input Impedance: 300 kOhm minimum
- Output Impedance: 200 Ohm maximum
- Gain: 60 dB maximum
- S/N Ratio: 70 dB
- Frequency Response: 70 Hz to 5 KHz
- Size: 4.8" L x 2.8 W x 2.0" H
- Weight 305 g
|
| |
|
 |
Dinosaur DGR-1 Grunge Screamer
- Input Impedance: 1 MOhm minimum
- Output Impedance: 100 Ohm minimum
- Gain: 65 dB maximum
- S/N Ratio: 70 dB
- Frequency Response: 70 Hz to 5 KHz
- Size: 4.8" L x 2.8 W x 2.0" H
|
| |
|
 |
Dinosaur DFL-1 Flanger
- Input Impedance: 300 kOhm minimum
- Output Impedance: 200 Ohm maximum
- Gain: 0 dB maximum
- S/N Ratio: 70 dB
- Frequency Response: 70 Hz to 5 KHz
- Size: 4.8" L x 2.8 W x 2.0" H
- Weight 320 g
|
| |
|
 |
Dinosaur DCH-1 Chorus
- Input Impedance: 300 kOhm minimum
- Output Impedance: 200 Ohm maximum
- Gain: 0 dB maximum
- S/N Ratio: 85 dB
- Frequency Response: 70 Hz to 5 KHz
- Size: 4.8" L x 2.8 W x 2.0" H
- Weight 320 g
|
| |
|
 |
Eleca EWP-1 Wah Pedal
- Input Impedance: >1MΩ
- Output Impedance: <1MΩ
- Signal to noise: >102 dB A weighted
- Heel Down: 400 Hz
- Toe Down: 2 KHz
- Gain: >15 dB (at center frequencies of WAH)
- Bypass: Low noise class A, low source impedance, operational amplifier driver
- Switching: Noise free controlled by Carling switch
- Die-cast Metal Housing
All specifications +/- 5% unless otherwise stated
|
| |
|
 |
Dinosaur Overdrive / Distortion / Chorus / Delay Multi-Effects Pedal
- Overdrive Gain: 40 dB
- Distortion Gain: 40 dB
- Delay time: 50 ms - 450 ms (digital delay)
- Switches: Effect foot switch, Bypass foot switch
- Indicators: Effect indicator x 3, Bypass indicator x 1
- Controls: Overdrive/Distortion - Drive, Dist, Tone, Level
Chorus: Depth, Speed, Level
Digital Delay: Feedback, Short-Long, Time, Level
Master Level
|
| |
|
 |
Dinosaur Distortion / Chorus / Wah Multi-Effects Pedal
- Effects: Distortion, Chorus, Wah
- Switches: Wah on/off, Distortion on/off, Chorus on/off
- Controls: Distortion - Level, Dist, Tone
Chorus: level, depth, speed
- Weight: 5 lbs (die-cast metal)
|
| |
|